Maxim-integrated 78M6618 PDU1 Firmware Uživatelský manuál stáhnout pdf (Strana 12)

78M6618 PDU1 Firmware Quick Start Guide UG_6618_122

12 Rev.0

4 Getting Started with Flash Programming

4.1 Via the GUI

If the Firmware includes a Boot Loader, the following steps describe how to use the GUI to upgrade the

Firmware using the Boot Loader:

1. On the SAI Commands tab, click the Invoke Boot Loader Mode button near the lower-left corner.

2. Power cycle the device, or send “Watchdog Reset” command. It will enter the Boot Load mode. This

can be verified by observing the DIO4 pin, which produces 15 ms pulses when the boot loader is in

operation.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18 19

Žádné komentáře

Maxim-integrated 78M6618 PDU1 Firmware Uživatelský manuál Strana 12