Maxim-integrated MAXQ7667 Uživatelský manuál stáhnout pdf (Strana 124)

__________________________________________________________________________________________________________ 6-30

MAXQ7667 User’s Guide

6.7.9.4 Measure Duty Cycle Repeatedly

To measure the duty cycle of the signal seen on the T2P0 input pin, the Type 2 timer is configured for a single-shot delayed run with

both edges defined for capture. The CPRL2 bits should be configured to 1 to request reloads on each edge. To prevent reloads on

ne of the edges, gating should be enabled. The T2POL0 bit specifies which edge starts/ends the capture cycle and which edge does

not have a reload associated with it.

; ------------------ Reset State: T2R0 = T2V0 = T2C0 = 0000h ------------------------

MOVE T2CFG0, #00000110b ; T2CI =0 (sysclk/N input)

; T2DIV2:0 =000 (/1)

; T2MD =0 (16-bit)

; CCF1:0 =11 (both edges)

; C/T2 =0 (timer/capture)

MOVE T2CNA0, #10101111b ; ET2 =1 (enable Type 2 Timer ints)

; T2OE0 =0 (input)

; T2POL0 =1 (no reload on rising edge

; single shot start/end on falling edge)

; TR2L:TR2 =01 (start timer on single shot condition)

; CPRL2 =1 (reload on capture edge)

; SS2 =1 (single shot mode)

; G2EN =1 (gating enabled)

; ------------------ TCC2 Interrupt : LOW TIME=T2C0

;------------------- TCC2 Interrupt : PERIOD = T2C0

T2P0 PIN

CODE EXECUTION:

POINT A

CODE EXECUTION:

POINT B

1B 3B

EVENTS:

1A: FALLING EDGE CAUSES CAPTURE/RELOAD; SINGLE-SHOT CAPTURE CYCLE BEGINS.

2A: RISING EDGE CAUSES CAPTURE; LOW TIME = T2C0.

3A: FALLING EDGE CAUSES CAPTURE/RELOAD; SINGLE-SHOT CAPTURE CYCLE ENDS; PERIOD = T2C0. TIMER CONTINUES TO OPERATE

SINCE TR2 = 1, ALLOWING THE NEXT LOW TIME/PERIOD TO BE MEASURED.

1B–3B: SAME SEQUENCE AS 1A–3A, EXCEPT THAT THE SINGLE-SHOT CAPTURE CYCLE DOES NOT BEGIN UNTIL THE FIRST FALLING EDGE IS DETECTED.

Figur

e 6-11. T

ype 2 T

imer Application Example—Measure Duty Cycle

1 2 ... 119 120 121 122 123 124 125 126 127 128 129 ... 346 347

Žádné komentáře

Maxim-integrated MAXQ7667 Uživatelský manuál Strana 124